Posted by Don-Wi on February 28, 2013 at 19:44:51 from (75.207.81.164):
I asked on the Massey board, but figured I'd try over here too-
What's all needed to put a 1000 PTO stub on a 285? I found a housing on craigslist for $25, but it doesn't have the shaft that I know of. Dad was always under the impression that all you needed was the shaft, but after looking at the AGCO parts books online, it does give different part #'s for the housings and shafts, but the rest is all the same.
It's nothing we NEED, but it's always been something we wanted if we could find it. The only thing on our farm that is 1000 RPM right now is our chopper, which we power with our Oliver 1855 that puts out 105 HP on the pto. Only reason I would try it on that is to try opening the fields with it as our 1855 doesn't fit between the rows so it always stamps down atleast 1 row. The 285 would atleast go between them.
I know that the shaft can be hard to find, and expensive when it is found. I found an aftermarket shaft on Ebay for a hair over $200 which actually doesn't seem too bad... No mention of the housing on there either though...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
