Posted by Fixerupper on February 08, 2013 at 14:21:06 from (100.42.82.30):
Just bought a tire changer-China made. I know, but by my understanding, they're all made there. Please, somebody refute that and tell me there IS an American made one out there.
The pressure recommendation for setting the pressure regulator is in bar instead of PSI. If my feeble memory serves me right the book mentioned setting the pressure at 8 bar. I coughed up a conversion table on the net and it gives two figures- PSI and PSI absolute. Straight 8 bar is 116 PSI. By the absolute figure 8 bar is 101 PSI absolute, meaning minus atmospheric air pressure. I assume the gauge on yours and my compressor reads plain PSI so I should set the pressure at 116. Sometimes I wish these charts wouldn't get technical so undereducated dummies like me don't get confused! LOL Do any of you guys and gals know the answer? Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.