Five years ago you where priced a remote for $50 then where surprised when the same remote/part was higher priced today. When you where priced the remote five years ago it was the current one in use. So they sold thousands of them. Now it is a service part. Once something becomes a non-current part the price is going to be higher. I do not care if it is a GM, Ford, or Dodge. Also I bet that the person that told you back in 2008 that the remote was $50 was the salesman not someone from the part's department. OEM remotes have been way more than $50 for years. He either did not know or he was low balling it because he sensed you where concerned about the cost.
Then you where charged for the part and then labor to program it. The $25 dollar charge is cheaper than most dealers have around here. Many of them have a $50 minimum charge. Also this is all brands. You are always going to pay labor to have a part installed or programed.
I will agree with the service order processing fee. I hate those type of things. Many Equipment dealer shops are charging a misc. shop fee. It is usually around $50. That is a rip off.
There are many places to get you car repaired. An OEM dealer is always going to be the highest cost place you can go to. Also the remotes usually can be programed by the owner using the owners manual. These remotes are also available on Ebay and many after market places that would have been half that high a price.
So even though you are PO at GM right now I would bet that the other brands would not have been much cheaper. I actually have had much worse results with Ford in my area. GM next and Dodge the best as far as dealer service/satisfaction.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
