Posted by rrlund on February 03, 2013 at 15:29:49 from (207.241.137.116):
In Reply to: Re: Only on Sunday posted by Tom in NE on February 03, 2013 at 15:18:06:
Kind of,but it was just like a brass nut about an inch long,threaded all the way through,connects that short brass rod to a steel rod that goes all the way to the bottom. It wasn't quite the same as 3/8ths bolt thread,a metric went on it,but a little loose,so I welded three of those metric nuts together,then the steel rod was too far gone,it woundn't hold on that. I cut one nut off and welded a 3/8ths on it,but that wouldn't start on it. Trouble I've got now,the steel rod was so rusted and pitted that even after I took the angle grinder to it to smooth it up,it won't seal right around the nut at the top. Gonna have to replace it,just hope I can get by til next Saturday so one of teh boys can help me with it again. We back filled it just enough to keep it from freezing. Put some blue styrofoam insulation board over it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
