Posted by Zachary Hoyt on January 31, 2013 at 08:42:10 from (50.122.169.86):
I have a Massey 35 on which I put a 101-102 loader about 4 years ago. The loader came off a 202 industrial tractor so I had to adapt things a bit to make it fit. I used the existing valves and hoses but the valve leaks and some of the hoses are getting to be in bad shape. The loader is powered off the internal pump that runs the 3 point hitch. I am planning to add a front mounted pump and replace the valve and the hoses. I'm looking at surplus center for the parts since they seem to have the best prices. I see that pumps are rated with a range of GPM at different speeds and that valves are rated at a single GPM. Do I need the GPM that the pump could put out at the maximum speed the engine will turn it to be lower than the valve rating or am I mixed up? I have a very limited understanding of hydraulics and how to set them up. Any advice will be much appreciated. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.