Have to agree, Spook. I seems that segment is dying. People are struggling in this economy to just survive, let alone have some toys and hobbies at a place in the country. Used to be lots of new mini-farms being established in my area, no longer. It all might recover, but I'm not expecting it. We are within an hour of the big city so the commute isn't too bad (if you have a job), but with higher gas prices it certainly is less attractive.
We got into raising some llamas, we enjoy showing them and the wife uses the fiber for spinning, weaving and doing knitting and crocheting. We thought we might sell some babies too, but there is no market now, anyone that has them now has all they want and no new folks are interested. Over the last 4 years I think I've seen two new houses being built in my immediate area, one was a replacement for a fire damaged one. I've noticed too in the 11 years we've been here just about all the livestock operations have vanished. I guess they are too busy running crops to mess with cows and steers and hogs. I don't even see as many horses as I used to, with high hay prices I can well understand.
We will be in the market for a CUT with a loader at some point in the next couple of years, but have to pay off the truck (almost there) and the car (next summer) first. Don't want to get into debt to JD, NH or Kubota credit companies, so a good used one looks like the ticket. We are getting into our late 50s and a loader to help clean up the barn sounds pretty nice now and into the future. Doing it all by hand now, dumping into a spreader attached to a '41 9N and spreading or piling it about every 3-4 days. The old N is fine for that and maybe running a mower and a rear blade, but not much else.
I wouldn't trade where we live for anything but I don't think many other folks can trade up to our life anymore.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
