Posted by Dave from MN on January 26, 2013 at 05:32:52 from (38.109.25.246):
Does any one have any suggestions. Pocket gophers have made it so I will need to put corn in the alfalfa ground. Just has gotten too rough, and the stand is thinning, and I want to get the hay feilds closer to home any way. 1st question is, any recommendation for a good hay mix for beef, will be on lighter ground. Planning on doing oats as a cover, cut and bale as forage at boot stage or.... If I can get some early mixture in some lighter soil ground that is is not ready yet for decent yeilding corn, I was planning on getting an annual grass mix of some sorts, and cut and bale early enough that I can get a high yeilding .3 or .5 soybean in after. Then let the oat cover crop mature and harvest as saleable small squares of straw and save the oats for creep and selling to horse spoilers. Would this work? Central mn. Or would I be better off getting the beans in early and hope for a wet late summer and get a quick growing mix hay seeded after the beans? Hay would be needed by late fall. Last few falls have been dry and cant see getting any decent germination /growth after soybeans. Any suggestions or advice. Just a trial this year, but eather way I need to establish a replacement for that alfalfa ground going to corn. Pleaee, no snide comments, asking for suggestions and advice. Re reading is a bit confusing. This would be (2) different feilds, one to be seeded in spring for an established few year hay feild, the other I want to some how get a double use off of to boost forage stocks, and also get some soybenas off as harvestable quality beans. Part of the reasoning is also as it is lighter ground and worked to death by previous operators I want a cover crop any way and would no till the soybeans in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
