Posted by samn40 on January 21, 2013 at 09:35:28 from (81.153.155.19):
In Reply to: barn ventilation posted by Greg K on January 21, 2013 at 08:57:17:
Probably no help to you in this case BUT..... it might be of use to some body else... We have to house the majority of our livestock for nearly 6 months every year.and we go daily from warm to cold...we get a lot of variations in temps. So we need a lot of cheap ventalation but we also need windbreak and protection from horizontal rain. So we put our corrugated on upside down with the edges pointing upwards and at least 3/8ths inch of a gap between the sheets.... Very little rain ever comes in, the air can exchange and we have loads of light. There are no wind problems either. Believe it or not the larger gap you can leave (up to 3/8ths") the better, as too close and the rain forms a bead which then accumulates and drips. We use this on the roof and sides though sometimes we also fit 'Yorkshire cladding' to the sides....3"X1" treated timber fitted vertically with about 1 inch gap between. Sam
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.