Had both rotator cuffs done in the past. First one turned out better than before I tore it. I had a large calcium deposit in there that was painful at times. I can move it where ever I want pain free. Had like a six pack cooler under my arm for a couple weeks and then the sling. Did all my own therapy at home. Therapist showed me what to do and as long as I did it and gained movement I could do it myself. Took probably 3 months before I felt save really moving it. The second one seemed to go easier at first but thought I wasn't going to gain full movement. Did something one day and it felt like I popped it again. Hurt like heck. After about an hour it felt like it was as good as new. I had all my motion back again and no pain. Doc thought there was some scare tissue that I tore that gave my movement back. A later xray for something else showed he had put 4 screws in it to hold it in place. The first doc took 1 1/2 hours to do it. Said it was the worst tear he had ever fixed. The second doc did it in 45 minutes. Nurse said that is all the time he allows to do one. I still have a lot of grinding sounds in it when I move it but I can scratch my back with either one. Good luck with yours and don't rush anything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.