Posted by Adirondack case guy on January 16, 2013 at 13:56:33 from (74.69.160.79):
I went out to my shop yesterday, and welded together this A Frame which bolts to a standard CatI cross drawbar. It is made from a peice of 3" channel, 2" angle iron, and some peices of pipe. Since we got the expected covering of snow last night, which covered the mud from the Jan. thaw, I went up to the sugar bush to skid out more firewood logs for the evaporators. I wanted to see how well the arch worked on my Kubota B2150 4wd. It met all my expectations and then some. I was a bit conserned about the front end lifting when the arch was way up. The only time the front even offer to raise was when I was bulling a log up over a stone ledge at one end of the woods. All I had to do was lower the arms and it settled rite back down. The choker ring is very handy also, allowing me drive the tractor up over the ledge and then snatch the log up over it. It not as handy as a winch would be, but this only cost me a dozen sticks of welding rod, couple of hrs, and some left over steel. To elaborate a bit; the short chain that is threaded through the top of the arch, with the clevis and choker ring, is fastened to the drawbar of the tractor, so when the arch is raised it retracts, about 16" and raises the but of the log if hooked short, or allows me to move forward , when lowered, with the tractor to get out of a hole I have chewed down in. I need to weld on some more 5/16 posts to hook my extra chains on though. They slip around the pipe that I welded at the top to carry them and drag on the ground Loren, the Acg
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
