Posted by George Marsh on January 08, 2013 at 03:41:28 from (50.104.202.156):
In Reply to: Re: OT 110 from 220 posted by old on January 07, 2013 at 21:44:47:
Old, I know first hand just how rude some people can be. As Dave2 would say, Lack of people skills.
I hope if you carefully read what I wrote, I wasn't getting on your case. Sorry if you thought I was. I try to show some degree of respect for people who have a difference in opinion.
I still think there is a double standard in how things are done and that is what I was pointing out. My electric company leaving one of their wires on the ground for 2+ years and only using a rod in the ground at my transformer.
Another one of my pet-pees is that the wire carrying current is also connected to the metal frame of my close dryer and electric range. Been that way for over 40 years and you can still get them wired that way. DOUBLE STANDARD.
Another double standard, as pointed out in a previous post, 220 volt Air conditioners, water heaters, electric furnaces, electric base board heaters all are controlled by breaking one leg of the 220v. But mention breaking just one leg on a 220v air compressor and look at how many people jump all over you. I personally have a hard time figuring out what the big deal is, but mention that and see how many code police jump on you because you are breaking a code. Forget code for a moment, say the code book hasn't been written yet, explain why it's ok for all the things I mention above to be controlled by breaking one leg, but it's not OK for an air compressor that is properly grounded.
Old, just watch how many people will jump on me now instead of explaining the DOUBLE STANDARD using logic without going to their code book or making personal attacks on me.
Look, I'm for safety too. Still alive after 50 years of working with electricity. Can't remember the last time I got shocked. Can't remember people here treating others with different opinions with respect.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
