Posted by Bob Bancroft on December 25, 2012 at 08:49:51 from (97.73.64.160):
Remember the little square box that hung on the milkhouse wall for holding the filters for the milk can strainer/funnel? I limit my left over o-rings, carb kits, valve kits, various seals and small gaskets to that. I don't know why. Yesterday I took advantage of mild weather to pressure wash off two of my antique tractors. A quick coupler on the washer hose got to leaking so bad at the end that pressure dropped. I just bothered to dig through my collection. I don't know why. It's more nostalgia that anything. There are left over transmission shims/etc. from before I had a shop when I laid out in the cold rebuilding a truck trans. Tomorrow I'll go to the local auto supply and look through their assortment. This o-ring looks more like the "fatter" generic o-ring anyway!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.