While I agree with John T. that it is all fact sensative and up to the local prosicuter. and that right to self defence laws vary from state to state. let's look at the facts as presented so far (assuming that they hold up as correct): 1.The son had been in a fight with the father before. 2. the Father had a restraining order agianst the son that he violated. 3. he agian started to fight the father ( hope that there is physical evedence to support this). 4. he was reportedly "high as a kite", witch a blood test will quickly prove/ disprove. 5. acording to the post by Thesmoothedeere, the son was shot once in the chest, witch stands to reason he was facing the shooter. Now, if the prosicuter decides to go after this, this is still america (no matter who is in the White House), and he will need to get a jury of 12 to agree with his asertions. If these are the facts and they hold up, I think the father is not in too much leagle trouble. emonital trama and dealing with the wife's opnion is another matter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.