Posted by KEH on December 16, 2012 at 15:53:41 from (209.213.19.196):
In Reply to: chicken coop question posted by NewEnglandFarmer on December 16, 2012 at 08:52:56:
Daughter got into having a few chickens. She has a small moveable coop and a short moveable net fence which is electrified. Coop and fence is moved to fresh grass occasionally. She also has a couple of guineas. She had six guinea chicks(called Keets) originally but a black snake got some. She put the snake on the wrong side of a Tarus Judge, which I posted about earlier. The 2 guineas are now grown. A hawk dived into the small fenced in area but missed killing a chicken. The 2 guineas attacked the hawk and ran it off. On occasion some animal has tried to get at the chickens, I think without success.
A small permanent coop was built. She and hubby put in posts and I installed a fence of 5 foot dog pen wire, with a few inches at the bottom turned out flat and buried. A top of dog pen wire was put on top of the pen. I built a gate of wire and red cedar and we put concrete under it. No chickens have been lost from that set up. No bite marks on that wire.
We had chickens for serious gastronomical purposes when I was a boy. They free ranged during the day and were put in a coop at night. Never lost one to a hawk, but people shot hawks then and hunted foxes and coons. Occasionally we caught a possum that had gotten in the chicken house. I don't remember eating any possum but once, and that was enough for me. The way to carry a possum, incidentally, is by the tail. If the possum tries to climb up his tale to bite you, just shake him down.
Dogs, raccoons, hawks, and sometimes possums are enemies of chickens in this area. Snakes will steal eggs and eat baby chicks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.