Posted by Brian G. NY on December 16, 2012 at 14:21:06 from (64.22.46.132):
In Reply to: Cutting Fire wood Today posted by Adirondack case guy on December 15, 2012 at 18:45:17:
I've used this type of setup for years but I have always used black poly pipe. I do have some PEX now so I may have to update.One of my stoves takes 22" and the other 25" so I have marks on the inner pipe so I can simply adjust for whichever stove I'm cutting for. Mine is on the same side as yours but on the lower part of the saw handle, closer to the log. I rarely take it off because I am usely cutting dead wood which needs little limbing. When I have to do a lot of limbing, I take it off; it's held on with just one heater hose clamp. My brother always made fun of it but I like my wood cut at the maximum length possible so I get the maximum output from each load. Unlike some of others, I always fell trees with the bar side of the saw down. I like to fell the tree one firewood length up from the ground and go back and cut the last piece as close to the ground as possible. Stumps left in the woods look like a waste to me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.