Posted by Russ from MN on December 14, 2012 at 17:05:10 from (68.235.89.15):
In Reply to: Sawing firewood. posted by JayinNY on December 14, 2012 at 16:48:13:
Exactly! it all burns! I cut mine all different lengths, we have 2 different stoves and our son has one that uses an in between size. I cut the really large diameter logs into shorter blocks so they are not so heavy to lift into the splitter and the shorter it is the faster it dries. Out stove takes 22" wood so I built our splitter to only take logs up to 22" I save the longer sticks for colder nights and use the shorter junk now when it's pretty warm. I have 22" marks on my trailers and wheelbarrows so if I think one is too long I can check it and maybe cut it in two for the smaller stove. Recently I skidded out some large ash trees (18" diaX60') and I will probably cut it up more consistent. I think I can eyeball to within an inch of 20".
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.