Posted by rabbit on December 13, 2012 at 06:27:20 from (207.241.137.116):
In Reply to: OT - BBQ Smoker posted by BigTone on December 13, 2012 at 06:06:26:
You can find a bunch of different flavors wood chips if you find the right store. Hickory and cherry are most common. I have a few apple trees here that shed enough branches to keep me in chunks of wood. I have an old fashioned Brinkman smoker. Basically a cheap drum with dome lid. Couple of grids on the top and a bowl for a charcoal fire on the bottom. Get the fire going, and throw in a handful of dampened wood chips. My recipe is to take strips of meat, roll them in mix of half salt, half sugar, and smoke them till fairly dry. Don't have to have heat very high, as you are drying the meat, nor burning it to a crisp. I usually only use one grid, as meat on lower grid seems to burn too easily. Turn meat at least once during process.
My butcher has a little room with hooks in the ceiling, A little gas burner on the floor, with a tray where he puts wet wood chips. Hangs sausages, etc on the hooks, sets it going at night, all done by morning.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.