Posted by Notjustair on November 30, 2012 at 18:41:52 from (174.255.1.99):
In Reply to: OT quitting smoking posted by bigboreG on November 30, 2012 at 15:42:47:
I quit two months ago, so I am a newbie. Mindset is really it. I wanted to quit very badly.
Since I am not the only one in the house that smokes I knew it would be hard. Since I have never smoked in the house in the last 20 years, winter was the time to do it as I hated to go outside in the winter to smoke.
I started inhaling only every other puff I took. After a while I upped that to only inhaling the first and last puffs, then only the last. About this time I noticed that I felt so much better and could taste. I noticed that they also gave me a bad taste in my mouth. Duh!
When I smoked for a week never inhaling I was ready to quit. It wasn't satisfying anyway. I did and haven't looked back. Weird way to do it but it worked for me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.