Posted by John T on November 25, 2012 at 07:58:20 from (216.249.82.117):
In Reply to: Ignition question posted by Notjustair on November 25, 2012 at 07:30:47:
While the old saying "if it aint broke dont fix it" has merit, its just NOT how Im wired and how I operate, IM A NUT ON PREVENTIVE MAINTENANCE. That beind said, before I start an engine after its sat a long time and it only takes a few minutes, is to at least open the points and as non abrasivley as possible (maybe use a dollar bill) lightly clean/buff/polish the point surfaces to remove any gray oxide coating or oil etc. I think doing so can greatly extend their life. Of course, if badly burned or pitted or carboned up,,,, replace
I agree the quality of points and condensor dont seem what it used to be, Ive seen new out of the box BAD condensors and I question if the silvery coating on the points is the quality it used to be.
One of the worst enemies of points (in addition to excess current) life is a weak or open or incorrect value of condensor and perhaps even if the point quality was the same its the poor condensors that shortens the life of the points.
Sooooooooo if its running fine I guess you can or should???? leave things alone, but Im still a believer in occassional light clean/buff of points surfaces to remve oil or oxidation and thats also a goot time to check the gap anyway
Thats my story n Ima stickin to it based on yearssssssssssss and experience being a used tractor dealer and user......
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.