Depends on what type of chisel you are wanting to use. I had a 7 shank 3 point that was a load at about6" deep on my 5000 Ford, the 4000 only would handle 5 shanks and they were on 12" spacing. Now if you are talking about a disc chisel then they will be on a 15" spacing if like was made when I had mine or now possibly a wider spacing yet and the deeper you want to go the wider you need to be so for that depth I think you are looking at a disk chisel with the 15" spacing and it would take at least twice the horsepower per shank of the Ford unit that I had and at 6" and 8 hp per shank it was a load and only used it on higher rolling ground that was in bean stubble so sod would take a lot more. I am thinking that the depth you are wanting to go with other conditions figure at least 25 (not 20) horsepower per shank. so it would not be over a 4 shank disk chisel and have not heard of any of less than 5 shanks. Now if you want a plain 12" spacing unit and 6" deep then a 7 shank mounted would work. And they will not work in corn stalks.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
