Posted by dave2 on November 14, 2012 at 03:36:16 from (79.240.159.167):
Tuesday (yesterday) at quittin time, the back half was ready for shingles. This morning 3 guys show up at 0800 and stripped the frt half and were cleaned up/ ready to start the rebuild by 1130. Couple pics of what timber frame construction looked like in 1904. The upstairs floor and ceilings in this house are 8x8 beams with the middle filled with wedged in sticks and a mixture of clay, dirt, gravel, and straw. Walls the same but the exterior had brick in some places then all was stuccoed with an inch or so of clay and straw. Now, the floors, ceilings and walls will stay the same the roof will be insulated. Planning on the outside walls being insulated and wood siding going on next year, but the guy installing the heater and also does insulation said that insulating the walls won't be worth the time and money compared to the energy savings. Guess kinda like daylight savings time. may keep a little heat from going out but will also keep the sun from warming the stuccoed walls.... Anyway, here's the pics... Windows were just stuck in there when I replaced all the others, that wall will get another 4 inches of insulation and they'll be installed permanent.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
