Posted by Indiana Ken on November 09, 2012 at 05:01:37 from (66.249.234.243):
In Reply to: Pre-staked nuts posted by oldtanker on November 08, 2012 at 19:01:54:
There are various styles of locking nuts. The stover styles, flexloc nuts and nylon-insert locknuts are many times listed as reuseable. Another type referred to as centerlock are typically listed as not reuseable. Any good industrial supply company such as McMaster-Carr will carry the various types.
Either way, reuseable or not, you should always check the running torque during installation of any locking type nut. The running torque is the the torque required to turn the nut when it is has full thread engagement but before it begins to clamp against the mating part.
If you do not want the nuts to loosen the most important procedure is to torque the bolts at installation. If torque specifications are available for the machine use those, other wise use the standard value for the grade of bolt and thread type. Proper torque is also good (the best) insurance to prevent bolt breakage and the nuts from backing off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.