Posted by Suffolk1 on October 30, 2012 at 05:39:30 from (72.13.214.110):
I am working on an older combine and cleaning up a lot of the previous owners' alterations or emergency repairs. Has a six cylinder gas engine and the mechanical fuel pump has been replaced with an electric fuel pump. The fuel line from the fuel tank to the carburetor consists of a long, cobbled together, combination of steel line, 1/8 inch copper tubing, and 1/4 inch flexible fuel line hose. By relocating the electric fuel pump, I can cut the overall length of the fuel line by 1/2 or 2/3. Obviously the quickest and simplest solution is to use flexible fuel line hose, but the durability is not the best for the long haul. It is more difficult to shape and bend the steel tubing without kinking for a custom fit job and I don't have the tools to make the double flares on the ends. Are there any disadvantages to using copper tubing for the fuel line? It's much easier to cut, bend, and shape for a neat fit. Also, what would be preferred for fuel lines--flared fittings or compression fittings? Thanks for your input or experiences.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.