Posted by petetherookie on October 26, 2012 at 16:42:46 from (74.78.21.209):
Got done doing paperwork today at about 3. By 330 I had fired up Hercules and was at it again and a large stump. Working the ground around it with the hoe bucket. Finding and breaking major roots around it. Notice engine is running a wee bit off. Rev it up and let it run. Seems weak. Settle it back down to a high idle. Runs ok. That was dumb. Get back to work. Engine labors even now and then, but keeps going so I keep at the stump. dumber. Going after real thick multi branch root system. Slowly chewing it up, snapping big roots. Engine starts fluttering. I finally get the idea something ain't right. Pull up hoe, stabilizers. Just getting to lift bucket and it stalls. FUEL! Duh. Sure enough low, not empty but tractor is pitched back on a slope. Run to mobil and get 5 gallons. In it goes. Time to bleed before I kill the batteries. Crack open bottom of second filer. Diesel flows out. Closed, cracked open bleeder at top of filters, flows, Crack open small bleed on side of Cav. Dribles. Full throttle, crank it. Nada. Hmmm. thought best I crack lines at injectors. Can't swing bat tray out as loader is in the way. Getting dark. Engine cooling down but still warm. Manage to crack open front and middle injectors lines. Can get at back one. Crank it for about 15 seconds 2 times. Check injectors. Some fuel but not alot. Open lines a few more turns and crank it longer twice. More fuel. Now its getting darker. Gather up tools off the grass. Tighten injectors lines back up. After another full throttle crank with no combustion I stop. Batteries still holding up. Set throttle to fast idle. Started up on second crank. Ran ok, set it at high idle. Ran good. Lucky.disengaged from battle with stump. Let tractor sit running for 5 minutes. Lucky. Tomorrow that stumps going down. Pete
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
