Posted by JDseller on October 26, 2012 at 07:49:18 from (208.126.196.144):
In Reply to: Re: Tractor pulling. posted by dboll on October 26, 2012 at 06:53:03:
Well I don't really care what you spend your money on. I spend mine on things I like and you spend yours how you want.
As for the type of pull/race I was talking about READ my post carefully. I said after weight AND SAFETY rules, run what you bring. Your speed limit is a safety rule!!!! That is the class you want to run in. So great!!!
I think watching a tractor you have all hopped up going 3 MPH down the track is like watching paint dry. That is just my Opinion.
I am sure you would find many things I do just as boring to you.
The main classes I have been around where the super stock tractor pulls. Remember this was 20-30 years ago too. At that time they had a rule that the tractors where supposed to have only have certain engine blocks and such. The guy that won the nationals was not far from me. I know he had the numbers recast in the side of a larger engine block. So he had a larger displacement engine than he was supposed to. He got away with it for years.
There is one common factor. Tractor pulling guys have the thinnest skin of all the different speed freaks out there. Tell a drag racer that many are pushing the "rules" and he will laugh and say SOOOOOO. Tell a dirt track guy that and he will tell which one is doing it the most. The tractor pulling guy will argue with you for an hour that it is not happening. Then one of the guys listening will come and ask about changing the gears in his tractor so he can run a different speed in a gear limited pull.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
