AS I previously stated my question has nothing to do with the "high cost of a ported filter cover" but rather will it work/not work on a 10 or 20 series RC tractor. I think it will work and you state it won't work. This not about arguing but accurate information. All I'm searching for is PROOF.
You brought up a bolt part number(R65894 11" long)that was used on high filtration kits(longer filter) and PS trans. The bolt(R54750 8.5" long) I was referring to is a common part # between 3020/4020 & 4230 plus others and is listed as the bolt for a ported filter cover. If the bolt(R54750) is common to the above mentioned tractors and the hyd filter(AR75603) is common and the filter cover(R39796) then how can the recesses in trans be different and where did you get this information???
Thank you for any clarification,Jim
BTW according to my search in pc 1116 there's no sn break on the R65894 bolt at 205,000 for a 4020
This post was edited by Tx Jim at 04:34:11 10/25/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.