TXJim: The cover T31170 was never made for the JD 3020 and JD 3010 tractors. It was used mainly on the Mannheim designed tractors. Then they did offer it for use in the JD 30 and 40 series tractors WITH adapter spacer #7. That was to make the stack height the same.
Now to your original question. The bolt is used in different tractors because the total stack height is the same. They have different covers to fit the different transmission recess. If you put a T31170 on a JD 3020 the cover is the wrong depth to work right. It is too tall so the filter is not sealed. Plus the bolt number R65894 was not used on the JD 3020 or JD 3010. Only the JD 4020 under 205000-. Then in a bunch of other later model tractors. This bolt is used with different covers.
Truthfully I never wasted enough time to figure all the different covers/bolt/filters out. I just usually drilled and tapped a hole in the cover and called it good enough. Most customers we had would have had a cow if we put close to $500 in just getting a return ported cover on a tractor.
About the only time I used a factory ported cover was if the tractor already had one.
Also I never welded a fitting to the cover. Just drill and tape 3/4 x 16 hole and screw the fitting in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
