Years ago, mother has us cultivate up a part of the back yard for an new garden. We were getting the sod pretty well broken up by the 4th or 5th pass, when the cultivator came out of the ground with the center section of a gold pocket watch case on a spike point. Later we found the inner rear cover. For years after that I searched that garden plot with a metal detector. An old lady who worked for the former owners, said that spot was where they used to repair machines. The ground is filled with bits of broken nails, pipe, fittings, bolts /nuts and other small scrap. The metal detector finds several "hits" per foot, when set on iron and nearly as much when set to produce a different sound for non magnetic metals like gold or brass. I have found brass door lock plates, brass shell casings and brass plumbing, but no more covers or parts from that gold pocket watch. Kind of a shame, as I hoped the covers might be engraved with the owners name. A clock and watch collector I showed the center case section to, said it was a "Lever set" pocket watch, which would date from 1860 or earlier. The steel watch movement was reduced to a ring of rust inside the gold case, so nothing there. I suspect the gold watch covers are either not there, or are hidden under some of the larger bits of iron that masks them from the metal detector.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.