Posted by CB in central NY on October 09, 2012 at 12:54:58 from (216.81.81.81):
Calling all plumbers (and others)!
I've posted a few times recently concerning a waterline issue I had. Well, turns out the pipe went bad (full of holes) and needed to be replaced. That was accomplished a few days ago. I had to hire a horizontal driller to run the pipe under the road to the tune of big $$$.
Anyway, I am now trying to calculate the flow rate through this pipe. What I have is a concrete cistern from which I am sucking water to the house with a shallow-well pump. The specs are as follows:
1/2 HP pump putting out a max of 8.5 GPM (6.5 at 40 PSI)
240' of 1" plastic pipe
Water pressure tank - 29.5 gallons with a drawdown of 8.9 gallons
Waterline runs between 4 and 10 feet deep underground
It takes my pump about 4.5 minutes to fill the tank going from 30 PSI to cutting out at 50 PSI. I have heard that a pump should run no more than 1.5 - 2 minutes at a time. I am just trying to calculate flow rate through the pipe and see if my pump is too small for the setup I have. Yes, I know that tees and ells and such create drag and effectively make a longer pipe, but the websites I've visited don't seem to give me a formula for what I want. Any and all help would be appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.