Posted by Old Bob on October 08, 2012 at 18:31:30 from (69.29.103.76):
I posted a few days ago about my Super 88 Oliver that is stuck. Tractor has been in a barn out of the weather for 4 or 5 years. Ran when I put it in the barn. Had to stick from condensation.
Now for my question: I have the cylinders soaking with penetrating fluid, transmission fluid, diesel fuel, etc. I jacked up one of the rear wheels and attached a stick of square tubing about 12 feet long to the wheel by bolting it to the hub bolts in the center of the wheel. Then I put the tractor in road gear and placed a couple of concrete blocks on the end of the square tubing. The blocks are approximately 3 feet off the ground. When I moved the square tubing up and down the wheel that was not jacked up and was sitting on the ground spun in the opposite direction of the wheel that was jacked up. What do I need to do to make the leverage from the square tubing transfer to the engine, rather than spinning the wheel that is not jacked up and is sitting on the ground??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.