Posted by MisterT on October 05, 2012 at 08:58:33 from (67.55.162.174):
In Reply to: Tire Change posted by Mike M on October 04, 2012 at 19:21:29:
Quoting Removed, click Modern View to see
The tire guy was probably a younger man who still had all his strength, and he probably also had the special tools needed to break the bead instead of one of those slide-hammer bead breakers.
An older guy, with shoulder problems, just doesn't get along all that well with a slide-hammer bead breaker, so we find it is easier to remove the tire/rim from the tractor, lay it down under the drawbar of another tractor, and then use a handy-man jack to break the beads, and if you can get your wife to stand on one side of the tire while you're working the opposite side up and over the rim, it really goes pretty fast.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.