Posted by Texasmark1 on October 05, 2012 at 06:38:02 from (67.142.175.26):
In Reply to: Re: AC compresser posted by DH in Carolina on October 04, 2012 at 06:17:48:
As the driven wheel gets larger in diameter (circumference increases), it takes more circumference of the driving wheel to complete one rev. As the circumference of the driven wheel increases to twice that of the drive wheel, the drive wheel has to make 2 revs to get one for the driven wheel, thus you have a 2:1 reduction gear. Since the engine contains the drive wheel and it has to run at a certain rpm to perform it's intended function, the AC compressor will run slower than it did.
I understood that the new compressor had the 3 groove chev on it which increased from 4" dia to 6" and it is the driven wheel. Obviously, if the two chevs swapped positions, the result would be just the opposite and yes the compressor would be putting out 1/3 more refrigerant and you could be looking at potential evaporator freezing problems.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.