Posted by Fritz Maurer on September 27, 2012 at 19:55:44 from (216.137.138.178):
For years I hated that little Tecumseh OHV140 screwed to my Miller Roughneck. It had this weird flaccid stumbling at high idle, but would smooth out under load when an arc was struck. That was with a new plug. As time went on, it would get worse until it was impossible to run a bead with all the backfiring, and also getting harder to start. On the way to a service call one day, I stopped and got a new L-48 so I wouldn't have the aggravation of starting it first thing in the morning. It started ok, but was running worse than ever. Besides all the backfiring, I had to have a helper momentarily close the choke every time I struck an arc, or it would quit every time the throttle snapped open. Mercifully, that was a small job and I was out of there in a couple hours, but I was determined to chop that engine up when I got home. Later that year, I needed that welder real bad. I grudgingly pulled it out of the corner where I had stuffed it, knowing what I was in for. The spark plug had gotten broken somehow, and as I started for the mower shop, I noticed a discarded plug mashed into the driveway. I thought I would just clean this one up since I only needed to run the welder a few minutes. It was a long-reach NGK from one of the snowmobiles, and I had to put about six gaskets on it so it would be short enough to fit the Tecumseh. And friends, that nasty old NGK cast a spell on that motor... No-load top-end completely smooth, no more silly antics, starts with piece of rope (never before possible)... that plug is in the engine yet today. All the years previous the plugs were Champions. My rather lengthy question, how can such a simple thing as a piece of wire through some porcelain be so radically different between manufacturers? I refuse to believe that Champion is a junk plug, but the results are what they are.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
