Posted by ridgelane on September 25, 2012 at 21:58:29 from (208.38.36.24):
In Reply to: Re: CV joints posted by old on September 25, 2012 at 08:33:23:
The CV joints are on a Hesston 1340 rotary mower conditioner. I realize the machine is not really old. I"ve used this unit on the same tractor for the last 8 years. Measured the drawbar length, pto length all fall within the required specs.
The shaft on this machine has two CV joints, one at the tractor, the other right at the machine before attaching to the driveline that takes power to the back end to run the diskbine.
It is greased often and alot, more than I figured it really needed to be greased. The lower window on my 1066 is always covered in grease spots at haying time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
