Posted by JDseller on September 22, 2012 at 20:53:14 from (208.126.196.144):
In Reply to: Re: Sickle Mower posted by Brandon Uecker on September 22, 2012 at 16:05:20:
Brandon The easy way to get them to pop off is to set your vise just loose on the section. then with the knife part of the section down and the knife back against the vise, basically you have it on edge. Then hit the section right above each rivet and they will shear and drop off. The ones in the head may not shear this way if you can't get the back to set against the vise. If it is not solid you can damage the sickle head. If I am in doubt I just grind them off. CAUTION!!! If you do this wrong you can break the knife back or bend it. So just be careful.
I have a Johnson sickle servicer to install and remove the rivets. On short sickles I can change them twice as fast as you can with the bolts. I don't like the bolts on a sickle mower because the high arch hold downs will drag in fine grass more. I just keep an extra sickle on the tractor with me. I can replace the sickle in less that five minutes. Then when I am not mowing later I can fix the bad section.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.