Yes, not here at home, but 30 miles north, at a residence that was part of the farm there, is a relative, a WWII veteran, bomber and fighter pilot, who gets domestic water from a pond adjacent to his house, not used for any livestock or accessed by anyone. Wells in this area or within this 50 acre place are just not productive enough, I think we have 3 driven or drilled wells, one has good cold spring water but it will run dry with heavy use, the others are ok, I honestly don't get the water situation there, seems to be a fair amount of sulfur and I think iron, judging by the water buckets.
Back to the question, he has a neat filtration system, pond gets covered with millfoil (Sp?) too, but the water is fine, every once in awhile you have to clear or check on the pick up, he still wades out, but I have done it for him. At first glance it just kind of turns a person off, but, he drilled one or 2 wells, they just could not produce.
The better idea, in this geological array of sand, clay and shale, was a 10' foot deep hole in the shale, or where the older deteriorated layer starts, was to place a filter fabric covered perforated precast round structure. 2 sections high with a lid it fills with 1200 gallons and if pumped out fills at a rapid pace, clean cold filtered water without the sulfur, and it produces even in the driest of weather, none of the wells can produce like that and there must be about 5 wells on this place. Thats what he should have instead of the pond, you just have to make sure and backfill over the top cover, we did not and you can get sediment, snakes squeeze in under somehow and can drop down in, die etc., if that was not an issue, I think it would test fine. Easy to shock, think it was a 1 1/2 gallons of chlorine to shock it and sanitize which I used to do. Its not much different than a stone lined hand dug well, sometimes deep is not the answer it seems, here they range 250'-300' and you can have annoying levels of sulfur or traces I have the latter and use a softener, never runs dry, or I've never pushed it in dry weather.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
