Texasmark1 said: (quoted from post at 09:29:09 09/18/12)This engine drives a 57 PTO hp 4wd tractor that I can hook to my 12' 14 shank JD chisel with 10" sweeps and 3 rows of fingers, and pull it in mid range gears just like my JD 100 hp 4230 did. Here's the kicker: I can plow the same acreage in the same time on HALF THE FUEL.
Mark
Mark
I dang sure think that your 57 pto HP MFWD(weighing according to Tractordata 5,808 lbs) CAN NOT pull a 14 shank chisel as fast and deep as a JD 4230 100 pto HP 2WD(weighing according to Tractordata 8100 to 14150 pounds. I'm curious how many inches in the ground are you pulling this 14 shank chisel with your Bransom tractor???????
This post was edited by Tx Jim at 11:50:26 09/18/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.