dave2, IMO and Experience Hole Depth has as More to do with a gate post as anything! Most people will Simply not dig a deep enough hole for the post. Then try to keep it in place with concrete. I will not begin to try to tell all the specifics for keeping post from walking out of the ground there. BUT I do know there is No Substitute for Hole depth for a set of Corner/Gate post. Here in Texas I prefer a 12in. hole, about 5+ ft deep.. Since we use a lot of heavy steel pipe for gate/corners then Drive 3ft to 4ft more below the bottom of the hole. Then Concrete it in........ So a set of corner,s or gate post would consist of a pipe post, 15/16 ft. long,,,7ft in the air 5ft in the hole, 4ft driven below the bottom of the hole. Post in the ground translates into strength and a post that doesn't move. I use this method on all my 5-post corners and 3-post gate end post. In other words you will need to do more than just a 4 ft post hole if you plan on keeping post in the ground in wet conditions and areas where the freeze/thaw will walk a post our if the ground. Hope this helps! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.