Posted by Fixerupper on September 11, 2012 at 18:51:22 from (100.42.82.164):
This evening I put a new bucket cylinder on the Westendorf loader. The price tag was $400+. The old one had been welded on and was leaking so the time had come to pitch it.
When I took the old one off I had the bucket tipped down at a 90 degree angle to the floor so the cylinder was fairly well extended. I took the old cylinder off, put the new one on with the top pin only. Since it was retracted I hooked up the hoses and then planned to extend it with the hydraulics. Well I was tired and when I went to extend it to the bottom pin hole I pulled the lever the wrong way, and then pushed it the wrong way, and to make a long story short, the ram ended up BENT. It isn't bent more than 1/8-3/16" and I can straighten it in the press in the morning, but I sure didn't have a good feeling in my gut when I got out of the cab and saw it.
I could have waited to replace it in the morning when I'm awake and fresh but no, I had to push the clock and get it done tonight! Nuff said! Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
