Posted by wisbaker on September 11, 2012 at 10:41:48 from (184.157.212.173):
In Reply to: Hey Old posted by oldtanker on September 11, 2012 at 06:42:50:
Have you tried any of the folks that advertise brake and suspension parts in Hemmings motor news? If it's odd fleet stuff and the truck is in good order how about switching the whole axle out with something newer and sustainable? Their are a lot of newer trucks that have been wrecked or rusted out and I would think you could scout up enough parts to make something work. IIRC Ford used the same frame width on their light duty stuff from 1947 until 1972, shouldn't be that hard to get suspension and brakes that work and have parts availability. Rear end what axle? Again you might be able to retrofit brakes from something newer that uses the same axle? Front- again maybe from the knuckle out can be swapped out, the front will be harder because Ford probably made the axle.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.