Watts are still watts. If your output watts are 600, the inverter's input watts will be, in theory only, 600 watts. So a 12 volt battery will need to produce 50 amps to equal 600 watts. My guess is the inverter will use some watts too, which will add to the 50 amp total. Divide your watts by 12 volts and that will be your amps. Guessing you have 12 volt battery on tractor.
If I were trying to do what you are doing, I would keep the tractor or truck running at an idle or fast idle. The slower the engine is running, the less the alternator can produce and IMHO the less stress you will put on the alternator.
I have a 10K dump trailer with a 12v hydraulic pump. I wire my dump trailer battery to the tractor's battery. When I make a dump, I slow the tractor down and watch my ammeter. Usually at an idle the alternator is producing 20 amps. It's a 61 amp alternator. To date, I haven't fried my alternator. At the end of the day, I put a charger on dump trailer battery to bring it up to full charge. You may want to do the same. George
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
