Posted by Don-Wi on September 03, 2012 at 18:59:16 from (75.249.110.1):
In Reply to: Haying done posted by wijim on September 03, 2012 at 07:47:43:
I see you're not too far from us. I live in Hilbert, work in Menasha on Midway right across from the UW, and the family farm is on the South side of Kaukauna. We baled 4th crop this weekend, and there is a slight potential for 5th crop. Very slight, but if the frost stays away for a while it could happen.
We're also eyeing up our 3rd cutting from the new seeding. It's tall enough and the clover in it is blossomed out, just gotta figure out when to chop it and where it's going. May go in the silo, but that's a b!tch for Dad to pitch out. No bagger here until we start corn hard, and that'll be another 2 weeks probably. I want to try getting some off this next weekend to test out the new chopper, but won't do much just a few loads, maybe fill the small silo which holds 9-10 loads of corn. Less if hay.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.