Posted by Buckeye Oliver collector on September 03, 2012 at 12:50:10 from (63.23.6.68):
Went to a tractor auction this morning a mile up the road. Probably typical of any auction; a few surprises both ways. They had a few parts tractors there (2 Wallis, F-12 etc.) but I did not get prices on them.
Cletrac E68 1550 OC3 1900 MM G705 new paint 4050 Case VAC new paint 1150 Case C new paint on full steel 1175 Farmall M wide front new paint 1900 H 1700 F-14 (poor rear tires) 625 F-20 new paint 1100 Centaur tractor 750 John Deere A (styled) newer paint 1950 B (styled) new paint 2000 H 2000 Oliver 77 with #4 Oliver picker 1850 28-44 new paint 2100 70 on full steel 975 The General by Cletrac 925 1928 50-62 Huber 5600 Rock Island 3300 1928 Baker 25-50 6000 Co-op E3 wide front 1600 8N Ford 1600
Thought the farmall H was kind of ridiculous (high) at 1700 and the 8N should have brought at least $500 more. Crawlers also seemed low but they can be big bucks too maintain.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
