Posted by GarryinNC on August 30, 2012 at 19:39:43 from (66.44.242.123):
I am working on a friends JD 5320 tractor. It quit running on him the other day shortly after pulling it out of the shed. The fuse in the circuit the powers the injection pump fuel solenoid blew every time you turned the key switch on. I finally pulled the relay marked 'start bypass' and straight wired the pump to get it running temporarily.
Today I did some more trouble shooting, thinking there might be a wire to the pump grounded some where. The pump has two wires on the hot terminal. The one from the switch turned out to be okay but the other wire goes up to a sensor near the top radiator hose. That wire is shorted to ground and was the problem. Left it unhooked, tractor starts and runs fine.
Look this part up on the JD parts website and it is listed as a cold start advance sensor. Was just wondering it purpose(emissions or something else) and how it makes the pump advance. I assume it means timing advance. Will replace sensor, but in the meantime will it cause any problems to operate tractor without it hooked up? We live in North Carolina if climate is any factor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
