If you absolutely need to be able to get around in two weeks, you're taking a gamble by doing it now, and you might very well end up with a knee just as bad as it is now. The recuperation time will vary a great deal depending on how much work the doctor does, and he won't know until he gets in there. You need to have a very frank talk with your orthopedist. Explain to him that you have harvest coming up and need full mobility in two weeks. Describe the activities you'll be doing (climbing on and off combines, operating vehicles with manual transmissions, etc.) and the hours you'll be working. I suspect he will recommend you postpone the surgery until after harvest.
Another thing to consider is rehab. Will you be able to take a couple of hours off two or three days a week during harvest? Are you going to be able to take it easy the rest of the day as the swelling goes down? I didn't think so. Again, you need to grill your doctor. Keep in mind that your surgery will make the payment on his Bonanza this month.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.