Posted by Diydave on August 25, 2012 at 18:11:45 from (96.244.156.45):
In Reply to: Re: The Limbinator posted by Kansas4010 on August 24, 2012 at 13:01:04:
Actually pinching is not as much of a problem, as you would think. I have not seen the setup, but most skid loaders have an instant reverse button, on the hydraulics, to back the saw out of a pinch. Also, the right way to use that saw would be the same way you would do it with a pole saw. Make a small cut, in the bottom of the limb, through the bark, and into the wood, a little, then make the top cut out, from the first cut, say about 6 Inches. Trim the stub, after the weight of the limb is gone, and you won't have to worry as much, about the bark at the bottom of the stub, ripping downward.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.