I'm not thinking he should work for free but he should be honest as far as the flat rate goes. I just looked it up online and a fair labor charge at his hourly rate should have been around 135 bucks, not close to 300. My BIL had already purchased the shaft on my account trying to save that generous 30-40% mechanic's mark up so that quote did not include parts. This is the first time I've let him use my account to get a part.
Most of the time I refuse to do auto repairs for people or I charge what they would pay any shop in the area but tell em it's on my schedule and I take my sweet time about that. In my BIL's case he has used that mechanic for years but right now can't work and is still trying to get back on his feet. Right now he's lucky his 2 sons are both working and still at home. He had to sell both his car and truck to pay on med bills not covered by his insurance and he got the Tempo cheap to replace them.
Now as far as a mechanic having to make money.....most of the decent shops in my area are 2-3 weeks behind in thier work. That is how my former boss's place was when I worked for him. Now he is waiting for work to come to him which should tell you something sence everyone else is swamped. Heck we got a young guy who just opened a shop this spring as a one man operation. His 1st month he ran up a 600 bill at the local parts place. Last month he spent very close to 4K. Not too bad for a kid who hasn't even run any ads and just has his shop in the yellow pages.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
