Dave maybe just make a stop so you can't raise the three point control lever any higher. I have one made for when I use my rotary cutter. If you raise it too high it bends the PTO shaft. I just took a small carriage bolt the would fit into the slot the lever slides in. I then put a larger washer and a wing nut on the bolt. I just pop it in the slot and slide it down against the lever. So I just raise the mower up until the PTO is close. Then slide the bolt down against the lever and tighten the wing nut. So I have a down stop for setting the cutting height and an up stop to keep the PTO safe. I use it with my three point mounted hay tedder too. It will break the PTO yoke if raised too high.
On some of my other tractors you don't have an exposed slot. I just cut a small piece of wood and then wire tie it to make a positive up stop. Use it with the round bale mover on any of the cab tractors. If you raise the bale too high it will hit the back window.
Maybe you can make some thing like that to put on when you are using the PTO on a drawn implement.
Some of the old MFs had an adjustable top stop. I know my Uncle's MF 165 did. I think you where supposed to use it to let the lever back into a constant pump position for using external valves but it worked to keep the three point limited as well.
I also have seen guys just take a small pair of Vise grips and clamp the lever so it does not move at all when they want to hold a constant position.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.