Given the constraints of time and space, I'll add my 2c worth. 1. Your son shoots OK from the bench so at least he's doing something right. Next, I'd move him to the prone position with a sandbag rest. The prone position is the steadiest of all positions and is important considering he's only 8 years old. Here, he should lie with his legs outspread and his body at about a 45 degree angle to the left of the gun/target line (for a right handed shooter). The left elbow should be directly under the rifle and the rifle should rest on the heel of the palm. This way, the rifle will be largely supported by bones rather than muscles which will provide a relatively stable platform. A properly adjusted sling will help. This will enable him to better HOLD THE RIFLE STEADY. This is what he was able to do at the bench but is now having trouble with. 2. Aiming and trigger squeeze. Briefly, if the sights are aligned correctly on the target when the rifle goes off, the bullet will hit on the target as desired. One way to accomplish this is to only squeeze the trigger when the sights are properly aligned. This means stopping the squeeze when the sights, due to rifle wobble, waver off the target and picking up the squeeze when the sights are again perfectly aligned. This means the firer will not know precisely when the rifle will fire which will help to prevent flinching and yanking the trigger. Yanking the trigger will almost always result in a miss. It's important to relax during this phase and breathing becomes a necessary nuisance because of the body movement it causes. You taught your son to fully let out his breath which is not the way to do it. What works best for me is to breathe normally until just as I'm taking up the trigger slack I take a normal breath and let out half of it and continue with coordinated aiming and squeezing. This becomes automatic after a while but you have to get to know the rifle's trigger pull characteristics. I wouldn't do that with a "hair trigger". (;>))At any rate, don't have him "breathe all the air out of his lungs". 3. Fire groups of three shots each and teach him how to "call his shots" and score/critique each group. Talk it over with him. If two of his shots were right on the mark but one was off, does he know which one probably was off the mark and why? Make any necessary adjustments and try, try again. 4. After sufficient time firing from the prone position he should be doing quite well and his confidence to hit what he's aiming at be at a point where he can take up a position much more useful for hunting. 5. The sitting position. When you told him to use "his knee to steady on", what did you mean? A really big mistake is to put the elbows on the knees. The loose cartilage of the elbows and kneecaps will cause wobble. And when you said "knee", did you mean just one knee? That would be the kneeling position, not the sitting position. Don't teach him the kneeling position just yet. The proper sitting position is much more stable than kneeling and just as useful for hunting as it gets the firer and his rifle up out of the vegetation. There's a lot more to it but with all the advice you've been given in this thread you and that fine boy of yours should be able to get'r done.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
