You may want to see if you can find some military field manuals on marksmanship, ebay or surplus store, good info in them, help both you and him, rationale is they schooled masses of people on how to accomplish results, will have all the positions, good reference material at least and should be easy to source, he may need to grow a bit, but sooner or later he will figure it out. I remember the first time I shot a .22, was in first grade, was a rifle, I could barely hold it up in a standing position, relaxed down to a hip just to get the feel of it, my dad was always busy, or short on time, was a friend of moms over for dinner husband and wife, he brought a .22 rifle to plink with after, I thought that was really cool, as there was no way my dad would have done this, they were not cool about anything actually LOL, but the opportunity to shoot and the experience was priceless. Years later I pressed him on it, went out a few times, that was it, figured it out on my own and I used military manuals, from school, as it had a JROTC program, had a rifle team and a tactical team, qualified at the National Guard range with the M16, anf 1911 .45 starting as a freshman, that was good stuff in those days ! Junior and Senior years, we went to one of the ranges at West Point, if we learned nothing else, we sure learned some marksmanship.
Like was said below, practice and practice again, might get tired or just off if too much, knock off, try again asap, the bench ought to build confidence for the other positions, not easy, I remember how heavy that rifle was to me then, nice experience for a father to teach a son marksmanship, and SAFETY, too ! Be good to hear back in a few weeks, bet he improves too !!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.